Limited Time Discount Offer
30% Off - Ends in 02:00:00

X

EMC E20-611 Dumps

EMC
CLARiiON Installation and Troubleshooting Specialist
EMC
CLARiiON Installation and Troubleshooting Specialist

Questions & Answers for EMC E20-611

Showing 1-15 of 130 Questions

Question #1 - Topic 0

Click the Exhibit button
Your customer has reported back-end issues with their FC4700 array. You have run Fibre
Backend Isolation (FBI) and are analyzing the report.
Which is the most likely failing disk?

A. CRU130

B. CRU141

C. CRU143

D. CRU159

Question #2 - Topic 0

Which IP address is required when configuring Centralized monitor Email-Home during the
CLARalert ConnectEMC installation?

A. EMC ControlCenter Server

B. ESRS Gateway

C. Portal System

D. SMTP Server

Question #3 - Topic 0

What is NOT a valid feature of proactive hot sparing?

A. A Copy to Hot Spare operation can take place only on a redundant RAID group.

B. The Copy to Hot Spare can only be initiated manually by qualified support personnel via GUI or SecCLI.

C. There can be multiple Copy to Hot Spare operations taking place as long as they are on different RAID groups.

D. There can be only one active Copy to Hot Spare operation per RAID group.

Question #4 - Topic 0

Using EMC best practices what is the percentage of memory that should be allocated for
read cache?

A. 10%

B. 15%

C. 20%

D. 30%

Question #5 - Topic 0

Your customer has asked you to explain the RAID 5 parity and striping functions on a CX4
series array. How many stripes will you tell them occur on a disk before the parity block will
rotate to the next disk?

A. 4

B. 8

C. 16

D. 32

Question #6 - Topic 0

In FLARE release 24, what are the three tabs in an Enterprise Storage window?

A. General, Hosts, and Monitors

B. Hosts, Monitors, and Software

C. Hosts, Monitors, and Storage

D. Monitors, Software, and Storage

Question #7 - Topic 0

When reviewing SPCollect files, which utility is used?

A. CAP2

B. FBI

C. NST

D. SPLAT

Question #8 - Topic 0

During a CLARiiON conversion the Upgrade Wizard does not start automatically when the
SP is booted to the Utility Partition.
What is the most common problem and resolution?

A. The correct Conversion Image NDU package was not installed and the upgrade will need to be completed manually without the Upgrade Wizard.

B. The correct Conversion Image NDU package was not installed and the original hardware configuration will need to be swapped back so the correct Conversion Image can be installed.

C. The new hardware is not compatible and the original hardware configuration will need to be swapped back until compatible hardware is shipped to the site.

D. There is no fifth vault drive and the original hardware configuration will need to be swapped back so the fifth drive can be added to proceed with the conversion.

Question #9 - Topic 0

Which GUI utility in CAP2 displays storage processor event logs?

A. EIP

B. HEAT

C. SPLAT

D. SWAT

Question #10 - Topic 0

A disk in a RAID 5 set has failed. While performing the rebuild to the hot spare a
permanent CRC sector error is encountered on one of the remaining disks in the RAID
group.
What is the result of this occurrence?

A. The affected data will be lost even after the failed disk is replaced.

B. The affected data will be reconstructed by the SP and written to the hot spare.

C. The affected data will be unavailable until the failed disk is replaced.

D. The peer SP will attempt to read the sector.

Question #11 - Topic 0

Click the Exhibit button.
In the illustration, how should the I/O Annex correspond to the SPs from left to right?

A. SPA, SPA, SPB, SPB

B. SPA, SPB, SPA, SPB

C. SPB, SPA, SPB, SPA

D. SPB, SPB, SPA, SPA

Question #12 - Topic 0

The output file of an SPCollect generated from CAP2 is in which format?

A. doc

B. html

C. xml

D. zip

Question #13 - Topic 0

According to the procedure generator, as a general rule, in CLARiiON arrays with over 1
GB of cache, what is the minimum amount of memory that should be reserved for read
cache?

A. 200 MB

B. 300 MB

C. 400 MB

D. 600 MB

Question #14 - Topic 0

One of the rules fails in Navisphere Service Taskbar (NST) during a FLARE upgrade. You
are prompted for a password to override this individual failed rule.
Which password is used to override a failed rule?

A. clariion!

B. MESSNER

C. siw

D. SYR

Question #15 - Topic 0

A CLARiiON has two drives with bad sectors, an FC drive and an ATA drive.
How will the two different drive types handle the errors?

A. FC and ATA drives both have to be told by FLARE to remap a bad sector.

B. FC and ATA drives both remap bad sectors automatically without having to be told by FLARE.

C. FC drives have to be told by FLARE to remap a sector; ATA drives remap sectors automatically.

D. FC drives remap bad sectors automatically; ATA drives have to be told by FLARE to remap bad sectors.

×