Limited Time Discount Offer 30% Off - Ends in 02:00:00
×
practice exams:
Juniper JN0-340 Exam - uniper Networks Certified Internet Associate, J-series
Questions & Answers for Juniper JN0-340
Showing 1-15 of 120 Questions
Question #1 - Topic 0
Which two boot devices are availble on all J-series routers? (choose two)
A. USB
B. Hard Drive
C. PCMCIA Card
D. Compact Flash
Question #2 - Topic 0
Which major J-Web menu should you use to view the physical hardware in the router?
A. Monitor
B. Manage
C. Diagnose
D. Configuration
Question #3 - Topic 0
What is the purpose of an OSPF designated router?
A. It is the preferred exit point out of an area
B. It is the router which generates the default route
C. It reduces the OSPF traffic on a broadcast segment
D. It reduces the number of OSPF routes which are advertised on a segment
Question #4 - Topic 0
Which snapshot option creates a new partition table when using a new (non-JUNOS
software formatted) media?
A. format
B. device
C. partition
D. as-primary
Question #5 - Topic 0
Which J-Web menu displays the time the router last booted?
A. Monitor -> Time
B. Manage -> Time
C. Monitor -> System
D. Diagnose -> System
Question #6 - Topic 0
Which CLI command activates your configuration changes on the router?
A. save
B. commit
C. set run config
D. copy start run
Question #7 - Topic 0
Which syslog configuration option logs all CLI commands used on the router?
A. commands
B. change-log
C. authorization
D. interactive-commands
Question #8 - Topic 0
What are three reasons for using a routing policy? (Choose three.)
A. You want to rate limit ICMP packets to the router
B. You want to modify the rate of route advertisements
C. You want one protocol to receive routes from another protocol
D. You want to modify information associated with a route
E. You do not want to import all learned routes into the routing table
Question #9 - Topic 0
What J-Web menu should you use to add support for a second interface on a PIC?
A. Manage -> Files
B. Manage -> Reboot
C. Manage -> Upgrade
D. Manage -> Licenses
Question #10 - Topic 0
How do you disable the autoinstallation functionality on a J-series router?
A. Return the router to the factory default configuration
B. Reboot the router using the removable PCMCIA flash
C. Remove the autoinstallation configuration from the router
D. Compress the configuration button for more than 5 seconds
Question #11 - Topic 0
From the top of the configuration hierarchy, which CLI command displays the local AS
number configured on the router?
A. show bgp protocol
B. show protocols bgp
C. show routing-options
D. show bgp autonomous-system
Question #12 - Topic 0
A stateful firewall on a J-series router is applied to which interface?
A. WAN interface
B. Trusted interface
C. Loopback interface
D. Untrusted interfaace
Question #13 - Topic 0
How are multiple policies evaluated within the JUNOS software?
A. Alphabetically
B. As an ordered list
C. In a round robin manner
D. Numerically from lowest to highest
Question #14 - Topic 0
Which J-series router process is responsible for performing autoinstallation?
A. rpd
B. dhcpd
C. autod
D. slarpd
Question #15 - Topic 0
The use of NAT can break the operation of protocols which signal dymanic port numbers
within the packet flow. Which technology can be used in a NAT configuration to solve this
problem?
A. Stateful firewall
B. Intrusion detection
C. Port address translation
D. Application layer gateways
Comments for Question #1 - Topic 0